Reversal Circularly Polarized Luminescence of AIE‐Active Chiral Binaphthyl Molecules from Solution to Aggregation

Four aggregation‐induced emission (AIE)‐active chiral binaphthyl‐based molecules, (R/S)‐ 1 and (R/S)‐ 2 , were designed and synthesized. Interestingly, all of them can exhibit reversal circularly polarized luminescence (CPL) signals from solution to aggregation, which could be attributed to the different dihedral angle of binaphthyl units from cis‐conformation in pure THF solution to trans‐conformation in THF/water mixtures.     

Cs的覆盖度对Cs/石墨烯的结构稳定性和场发射性能影响

采用密度泛函理论方法,对Cs以不同覆盖度吸附在石墨烯表面时系统的结构稳定性和场发射性能进行了研究。计算结果表明单原子Cs吸附在石墨烯表面的碳六元环的中心位置时系统的能量最低。随着Cs的覆盖度增加,碱金属Cs与石墨烯之间的吸附作用逐渐增强,(4×4)R 0°和(2×2)R 0°结构是稳定的。由于碱金属Cs的修饰作用,Cs/石墨烯体系的功函明显下降,且随着碱金属Cs的覆盖度增大,系统的功函逐渐减小。态密度的计算结果表明功函的下降主要与Cs和石墨烯之间的电子转移有关。随着覆盖度的增大,石墨烯的电子态逐渐向低能方向移动,系统的费米能级升高并导致材料的功函下降。     

Aggregation‐Induced Emission of Hexaphenyl‐1,3‐butadiene

A new type of AIE molecules based on hexaphenyl‐1,3‐butadienes was reported with respect to the synthesis and characterization. This material exhibited different maximum emission wavelength and enhanced emission intensity at different aggregate state (amorphous and crystalline state).     

铝基火花源发射光谱仪测定MB1镁合金中锰含量

建立了用铝基体火花源原子发射光谱仪现有通道硬件测定镁合金(MB1)中锰元素含量的方法.方法线性相关系数为0.967 6,RSD为1.66%.对8个未知样品进行了测试,结果与化学分析方法所得结果一致.     

The electron microanalyzer (EPMA): a powerful device for the microanalysis of filled polymeric materials

The electron probe microanalyzer is a device often used in the field of geology or in the glass and steel industries. However, it is barely known or used in the polymer field. Thus, in this paper, we investigate the use of electron probe microanalyzer for polymer microanalyses and compared it with a scanning electron microscope equipped with an energy dispersive spectrometer. To show the unique potential of this technique only develop in our lab for polymer application, three different samples were studied: (i) a fire protective epoxy‐based coating submitted to aging in salt water, (ii) the distribution of organometallic catalysts into a thermal isolative silicone polymer, and (iii) the fouling growth of milk protein (biopolymer) on a stainless steel surface. Compared to an energy dispersive spectrometer, with an electron probe microanalyzer it is possible to quickly create X‐ray mappings of low concentration elements at a good resolution, as well as allowing the interpretation of the mechanism of action for the three samples which was impossible using only an energy dispersive spectrometer because of its too low detection resolution. Copyright © 2015 John Wiley & Sons, Ltd.     

Far‐Red and Near‐IR AIE‐Active Fluorescent Organic Nanoprobes with Enhanced Tumor‐Targeting Efficacy: Shape‐Specific Effects

The rational design of high‐performance fluorescent materials for cancer targeting in vivo is still challenging. A unique molecular design strategy is presented that involves tailoring aggregation‐induced emission (AIE)‐active organic molecules to realize preferable far‐red and NIR fluorescence, well‐controlled morphology (from rod‐like to spherical), and also tumor‐targeted bioimaging. The shape‐tailored organic quinoline–malononitrile (QM) nanoprobes are biocompatible and highly desirable for cell‐tracking applications. Impressively, the spherical shape of QM‐5 nanoaggregates exhibits excellent tumor‐targeted bioimaging performance after intravenously injection into mice, but not the rod‐like aggregates of QM‐2.     

White‐Light Emission Strategy of a Single Organic Compound with Aggregation‐Induced Emission and Delayed Fluorescence Properties

A novel white‐light‐emitting organic molecule, which consists of carbazolyl‐ and phenothiazinyl‐substituted benzophenone (OPC) and exhibits aggregation‐induced emission‐delayed fluorescence (AIE‐DF) and mechanofluorochromic properties was synthesized. The CIE color coordinates of OPC were directly measured with a non‐doped powder, which presented white‐emission coordinates (0.33, 0.33) at 244 K to 252 K and (0.35, 0.35) at 298 K. The asymmetric donor–acceptor–donor′ (D‐A‐D′) type of OPC exhibits an accurate inherited relationship from dicarbazolyl‐substituted benzophenone (O2C, D‐A‐D) and diphenothiazinyl‐substituted benzophenone (O2P, D′‐A‐D′). By purposefully selecting the two parent molecules, that is, O2C (blue) and O2P (yellow), the white‐light emission of OPC can be achieved in a single molecule. This finding provides a feasible molecular strategy to design new AIE‐DF white‐light‐emitting organic molecules.     

Organic Crystals with Near‐Infrared Amplified Spontaneous Emissions Based on 2′‐Hydroxychalcone Derivatives: Subtle Structure Modification but Great Property Change

A series of highly efficient deep red to near‐infrared (NIR) emissive organic crystals 1 – 3 based on the structurally simple 2′‐hydroxychalcone derivatives were synthesized through a simple one‐step condensation reaction. Crystal 1 displays the highest quantum yield (Φ_f) of 0.32 among the reported organic single crystals with an emission maximum (λ_em) over 710 nm. Comparison between the bright emissive crystals 1 – 3 and the nearly nonluminous compounds 4 – 7 clearly gives evidence that a subtle structure modification can arouse great property changes, which is instructive in designing new high‐efficiency organic luminescent materials. Notably, crystals 1 – 3 exhibit amplified spontaneous emissions (ASE) with extremely low thresholds. Thus, organic deep red to NIR emissive crystals with very high Φ_f have been obtained and are found to display the first example of NIR fluorescent crystal ASE.     

A Porous Tricyclooxacalixarene Cage Based on Tetraphenylethylene

A quadrangular prismatic tricyclooxacalixarene cage 1 based on tetraphenylethylene (TPE) was efficiently synthesized by a one‐pot S_NAr condensation reaction. As a result of the porous internal structure in the solid state, cage 1 exhibited a good CO₂ uptake capacity of 12.5 wt % and a high selectivity for CO₂ over N₂ adsorption of 80 (273 K, 1 bar) with a BET surface area of 432 m² g^?1. Formation of cage 1 led to the fluorescence of TPE being switched on in solution. The system was employed as a single‐molecule platform to study the mechanism of aggregation‐induced emission (AIE) by examining the restriction of intramolecular rotation (RIR).     

Raman spectroscopic detection for liquid and solid targets using a spatial heterodyne spectrometer

Spatial heterodyne Raman spectroscopy (SHRS) is a new type of effective method for the analysis of structure and composition of liquid and solid targets with the characteristics of no moving parts, high spectral resolution, high optical throughput and large field of view. The technique is very suitable for detecting the targets from long distances or under the conditions with ambient light, which is essential for the exploration of planetary surface. In order to have a better understanding of the ability of SHRS for the detection of liquid and solid targets, a breadboard was designed, built and calibrated. Signal to noise was estimated at different integration time or laser power for carbon tetrachloride. Pure materials or materials contained in bottles were both tested. The mixture of organic liquids or inorganic solids were tested. In order to test the detection ability for natural targets, some composition‐unknown rocks and pebbles were tested. The results have shown that SHRS can meet the requirements for the detection of weak Raman signal scattered from artificial or natural targets. Standoff detection of sulfur from 5‐m or 10‐m distance without using any telescope or collimation optics was also tried to test the high optical throughput of SHRS. The potential feasibility of standoff detection has been proved. Copyright © 2015 John Wiley & Sons, Ltd.